Instructions / Assembly

Fort Assembly
Phase 1
Phase Notes
• Assemble with hardware as shown.
Hardware needed:
• (12) D - NUT BARREL WH 5/16x7/8 - H100005
• (12) AD - WASHER LOCK EXT 12x19 - H100031
• (12) AC - WASHER LOCK EXT 8x19 - H100030
• (8) K - BOLT WH 5/16x2 - H100012
• (4) H - BOLT WH 5/16x1-1/2 - H100010
• (8) CK - SCREW PFH 8x2 - H100111
• (4) BS - SCREW PFH 8x1-3/4 - H100089
Parts needed:
• (2) E1 - FORT UPRIGHT - W101847
• (2) E2 - FORT UPRIGHT - W101139
• (2) H1 - FLOOR BRACE - W101848
• (2) H3 - FLOOR BRACE - W101844
• (2) M1 - GROUND BOARD - W101846
• (1) N2 - SWING BLOCK SAFETY RAIL - W101853
Step 3:
Pre-drill & attach 'H1'
Floor Brace to the outside of
'E1' & 'E2' Fort Uprights using
screws 'CK', as shown.
CK
H1
E2
K
AC
AC
AD
ADD
DAD
AD
H3
E1
E1
AC
K
AC
H
AC
AD
D
AD
H
AC
M1
M1
E1
E1
BS
E2
E2
E1
E1
H3
H1
N2
M1
M1
H3
Step 2: Level & attach 'H3' Floor Brace
to the inside of 'E1' & 'E2' Fort Uprights
using hardware 'D', 'AD', 'AC', & 'K', as
shown.
Step 1:
Attach 'M1' Ground Boards to the
outside of 'E1' & 'E2' Fort Uprights using
hardware 'D', 'AD', 'AC', & 'H', as shown.
Step 4: Pre-drill & attach 'N2' Swing
Block Safety Rail to the outside of
'E1' & 'E2' Fort Uprights using screws
'BS', as shown.
To prevent board splitting, you
must pre-drill each board with
a 1/8" drill bit, before attaching.
PILOT HOLES SHOULD
FACE OUTWARD ON
'E2' BOARDS.