Instructions / Assembly

QTY DESCRIPTION
2
CENTER SLIDE BRACE
M78
24 SCREW PFH 8x3
1
SLIDE RAIL 8'
BLUE
RIGHT
1 SLIDE RAIL 8' BLUE LEFT
SLIDE RAIL 8' BLUE LEFT
SLIDE RAIL 8' BLUE RIGHT
M78 CENTER SLIDE BRACE
8 FOOT SLIDE ASSEMBLY
PHASE 2
Phase Notes
● PLACE 1 SLIDE RAIL ON A FLAT SURFACE AND BEGIN INSERTING SLIDE BED AT THE BOTTOM OF THE
SLIDE RAIL. PUT SLIDE SUPPORT BOTTOM INTO THE SUPPORT POCKET AT THE BOTTOM OF THE
RAIL AND HAVE A HELPER BEND THE SLIDE BED TOWARDS THE TOP OF THE SLIDE AND INSERT
THE BED INTO THE SLIDE CAVITY. MAKE SURE SLIDE BED IS COMPLETELY DOWN IN THE SLIDE
CAVITY. SECURE USING (12) 3" SCREWS AT EACH OF THE PILOT HOLE LOCATIONS AS SHOWN BELOW .
● PLACE THE OTHER SLIDE RAIL ON A FLAT SURFACE WITH THE SLIDE CAVITY UP. HAVE A HELPER
HOLD THE TOP END OF SLIDE BED AND BEGIN INSERTING THE SLIDE BED AND SLIDE BRACES INTO
THE CAVITY AND SUPPORT POCKETS STARTING AT THE BOTTOM OF SLIDE AND WORKING UP TO
THE TOP. SECURE USING (12) 3" SCREWS AT EACH OF THE PILOT HOLE LOCATIONS AS SHOWN BELOW .
TIP: A HELPER IS REQUIRED FOR THIS PHASE.