Instructions / Assembly

QTY DESCRIPTION
1
SLIDE BRACE
M77
3 BOLT WH 5/16x1/2
3 NUT BARREL WH 5/16x5/8
3
WASHER LOCK EXT 12x19
1 SLIDE BED 8' YELLOW
3 5/8
8 5/8
13 5/8
1
NUT BARREL WH 5/16x5/8
WASHER LOCK EXT 12x19
M77 SLIDE BRACE
BOLT WH 5/16x1/2
SLIDE BED 8' YELLOW
8 FOOT SLIDE ASSEMBLY
PHASE 1
Phase Notes
● DRILL 3 HOLES AT ONE END OF THE PLASTIC SLIDE BED USING A 3/8" DRILL BIT AND USING THE
DIMENSIONS SHOWN BELOW. THIS END WILL BE THE TOP OF THE SLIDE.
● TAKE NOTE OF SLIDE BED SURFACE FINISH, THE DULL SIDE WILL BE TOWARDS THE GROUND. PLACE
SLIDE BRACE CENTERED ON THE BOTTOM (DULL SIDE) AND 1/4" FROM THE EDGE. TRANSFER HOLES
ON THE BOARD THROUGH THE SLIDE BED AS SHOWN BELOW. USE A 3/8" DRILL BIT.
● ATTACH SLIDE BRACE TO SLIDE USING HARDWARE SHOWN.
BOTTOM
TOP
BOTTOM
TIP: PREBENDING THE ENDS WILL EASE ASSEMBLY.
(SEE SLIDE ASSEMBLY
INSTALLATION STEP FOR
TOP MOUNTING HOLE
DRILLING DIMENSIONS).