Assembly Instructions

Figure 2
post
3. Remove the fixture fastener (E) from the firepit. Attach the firepit by aligning the post through the umbrella hole,
then tighten the fixture fastener (E) clockwise (see Figure 2).
Figure 5
Figure 4
Figure 3
6. Insert glass shield onto the top of firepit body (A) (see Figure 5).
WARNING
DO NOT touch the surface of glass shield
when in use or just after use. Allow 30
minutes after use to cool down to prevent
scalding.
E
D
B
D
C
umbrella hole
Glass shield
A
4. Insert 2pcs larger glass (C) into the groove of the clip (D), then tighten the bolts using Phillips screwdriver
(see Figure 3).
5. Insert 2pcs short glass (B) into the groove of the clip (D), make sure the arrow labels on the short glass are in
an upward direction, tighten the bolts using Phillips screwdriver, then remove the arrow labels from short glass
(see Figure 4).
6
arrow label