Assembly Instructions

SKU# 272-2400 Large Wood Arc Hammock Stand

Congratulations on purchasing the large wood

arc hammock stand to be used with most 13 ft

2-pt hammocks. We hope it helps provide

hours of relaxation. If you have questions

regarding this product, please contact

customer service via email : customerservice

@algomanet.com

Weight Limit 450 lbs.

Parts

(A)

(B)

(C)

(D)

(E)

(F)

(G)

(H)

(I)

(J)

(K)

(L)

(A) 9.5” Bolts (x 4)

(B) 5.5” Bolts (x 4)

(D) Lock Nuts (x 8)

(E) Eye bolts (x 2)

(F) Carabiner Clip (x 4)

(G) Chain (x 2)

(H) Wrench (x 2)

(I) Wrench handle (x 2)

(J) Upright supports (x 2)

(K) Base Supports (x 2)

(L) Legs (x 2)

Note: Wrenches for assembly are

provided, however, if using your own

tools, a 17mm metric, or 11/16” SAE

deep socket will be required.

2 piece

wrench

PAGE 1
SKU# 272-2400 Large Wood Arc Hammock Stand Weight Limit 450 lbs. Congratulations on purchasing the large wood arc hammock stand to be used with most 13 ft 2-pt hammocks. We hope it helps provide hours of relaxation. If you have questions regarding this product, please contact customer service via email : customerservice @algomanet.com Note: Wrenches for assembly are provided, however, if using your own tools, a 17mm metric, or 11/16” SAE deep socket will be required.
PAGE 2
(L) (L) Step 1: Place wood legs (L) on a hard level surface approximately 48 inches apart (as in figure 1) with the beveled cutout facing up, and towards each other. Figure 1 Step 2: Place one wood base support (K) onto wood legs (as in Figure 2). (The ends of the base support should be arching up and the countersunk holes on the sides of the base support to the outside). Line up the hole on the top of the base support with the hole in the beveled part of the legs. Place a washer (C) onto one of the 5.
PAGE 3
Figure 5 Step 4: Place eye bolt (E) into the hole at the top of the upright support (as shown in Figure 5) Secure using a washer (C) and a lock nut (D) tightening with the 2 piece wrenches supplied. Figure 6 Step 5: Clip a carabiner clip (F) onto each end of the chains (G). Attach the hanging chain to the eye bolt on each end of the stand (as shown in Figure 6.) Step 6: Go back and tighten all nuts and bolts.