Assembly Instructions

A
SEAT PART 1 BB
HEX BOLT
M6*20L
8
B
LEG 2 CC
METAL
WASHER
10
C
CONNECTO
R BAR
1 DD
PLASTIC
BOLT CAP
10
AA
HEX BOLT
M6*15L
2 EE
HEX
WRENCH
1
● Cover furniture with outdoor furniture covers when not in use.
● For safety reasons, do not sit or stand on the table.
Step 3
Turn the bench into the upright position. Your bench is ready for use.
IMPORTANT: To avoid damage to your table:
● In storing patio furniture, do not stack anything on glass, stone or marble table tops.
● Before storing, drain all water that may have accumulated in or around the frames.
● If not drained properly, water can cause freeze damage.
River Ridge Bench
272-5387
IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY!
Identify all parts packed in carton against the parts list. Remove all protective materials, place parts on a nonabrasive surface
to avoid scratching. If any parts are missing or damaged, DO NOT attempt to assemble. Please contact our customer service
center (Monday-Friday 8:30 a.m.-4:30 p.m. CST) at 1-800-426-2950 or e-mail: [e-mail].
PARTS LIST
Step 1
Attach the connector bar (C) to the leg (B) using two bolts (AA) and two washers (BB). Do not tighten the bolts until assembly
is complete.
Step 2
A. Attach the seat part (A) to the finished frame using eight bolts (BB) and eight washers (CC).
B. Tighten all bolts, then attach all the bolt caps (DD).