Assembly Instructions

A
CHAIR FRAME
1 BB
METAL
WASHER
8
B
CHAIR BASE
1 CC
SPRING
WASHER
4
C
T-ROCK
1 DD
NUT M8
4
D
RECTANGULA
R
STEEL PLATE
2 EE
PLASTIC BOLT
CAP M8
4
E
SEAT CUSHION
1 FF
PLASTIC
NUTCAP M8
4
AA
HEX BOLT
M8*45L
4 GG
HEX WRENCH
2
Mesa Ridge High Swivel Chair
272-5380
IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY!
Identify all parts packed in carton against the parts list. Remove all protective materials, place parts on a nonabrasive surface to avoid
scratching. If any parts are missing or damaged, DO NOT attempt to assemble. Please contact our customer service center (Monday-Friday
8:30 a.m.-4:30 p.m. CST) at 1-800-426-2950 or e-mail: [e-mail].
PARTS LIST
Step 1
A. Attach the T-rock (C) to the chair frame (A) using four bolts (AA) in the order of bolt (AA), metal washer (BB), rectangular steel plate (D),
metal washer (BB), spring washer (CC), and nut (DD). NOTE: Bolts are inserted from underneath the seat through the crossbar and into the
T-rock.
B. Tighten all bolts (AA) and nuts (DD) using hex wrench (GG). Cover all bolts and nuts with plastic bolt and nut caps (EE & FF).
● Cover furniture with outdoor furniture covers when not in use.
Step 2
Place the chair frame (A) into the chair base (B) by inserting the shaft directly into the plastic bushing of the chair base. Use a twisting motion
if necessary. Make sure you have inserted it all the way and that the base is locked onto the shaft.
Step 3
Put the seat cushion(E) into the seat, then your chair is ready for use.
IMPORTANT:
● Before storing, drain all water that may have accumulated in or around the frames.
● If not drained properly, water can cause freeze damage.