Assembly Instructions

ManualsBrandsBackyard Creations ManualsOutdoorsDanbury Swivel Rocker Dining Patio Chair - 2 Pack

LEFT ARM

1 BB

HEX BOLT

M6*50L

RIGHT ARM

1 CC

HEX BOLT

M8*45L

SEAT

1 DD

MENTAL

WASHER M6

BACK

1 EE

MENTAL

WASHER M8

T-ROCK

1 FF

SPRING

WASHER M8

BASE

1 GG

M8 NUT

SEAT CUSHION

1 HH

PLASTIC BOLT

CAP

LUMBAR

1 II

PLASTIC BOLT

CAP

RECTANGULAR

STEEL PLATE

4 JJ

PLASTIC

NUTCAP M8

HEX BOLT

M6*35L

4 KK

HEX WRENCH

Danbury Swivel Rocker

272-5376

IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY!

Identify all parts packed in carton against the parts list. Remove all protective materials, place parts on a nonabrasive surface to avoid

scratching. If any parts are missing or damaged, DO NOT attempt to assemble. Please contact our customer service center (Monday-

Friday 8:30 a.m.-4:30 p.m. CST) at 1-800-426-2950 or e-mail: cs@patiohelpdesk.com.

PARTS LIST

Step 1:

Attach the left arm (A) and right arm (B) to the seat (C) using four bolts (BB), four washers (DD) and four bolt caps (HH). Do not tighten

the bolts until assembly is complete.

Step 2: Attach the back (D) to the finished frame using four bolts (AA), four washers (DD) and four bolt caps (HH). Do not tighten the

bolts until assembly is complete.

Step 3:

A. Attach the T-rock (E) to the finished frame with four bolts in the order of bolt (CC), washer (EE), rectangular steel plate (I), washer (EE), spring washer

(FF), M8nut (GG).

B. Tighten all bolts (AA, BB & CC) and nuts (GG) using hex wrench (KK). Cover all bolts and nuts with plastic bolt and nut caps (HH, II & JJ).

IMPORTANT:

● Before storing, drain all water that may have accumulated in or around the frames.

● If not drained properly, water can cause freeze damage.

● Cover furniture with outdoor furniture covers when not in use.

Summary of content (2 pages)

PAGE 1
Danbury Swivel Rocker 272-5376 IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY! Identify all parts packed in carton against the parts list. Remove all protective materials, place parts on a nonabrasive surface to avoid scratching. If any parts are missing or damaged, DO NOT attempt to assemble. Please contact our customer service center (MondayFriday 8:30 a.m.-4:30 p.m. CST) at 1-800-426-2950 or e-mail: cs@patiohelpdesk.com.
PAGE 2
Step 4: Place the finished frame into the chair base (F) by inserting the shaft directly into the plastic bushing of the chair base. Use a twisting motion if necessary. Make sure you have inserted it all the way and that the base is locked onto the shaft. Step 5: Put the seat cushion (G) and lumbar (H) into the seat, then your chair is ready for use.