Assembly Instructions

A
CHAIR FRAME
1 DD
METAL
WASHER
M8
8
B
CHAIR BUCKET
1 EE
SPRING
WASHER
4
C
T-ROCK
1 FF
NUT M8
4
D
CHAIR BASE
1 GG
PLASTIC BOLT
CAP M6
4
E
RECTANGULA
R
STEEL PLATE
1 HH
PLASTIC BOLT
CAP M8
4
AA
HEX BOLT
M6*35L
4 II
PLASTIC
NUTCAP M8
4
BB
HEX BOLT
M8*45L
4 JJ
HEX WRENCH
2
CC
METAL
WASHER
M6
4
● Cover furniture with outdoor furniture covers when not in use.
Step 3
A. Place the finished frame into the chair base (D) by inserting the shaft directly into the plastic bushing of the chair base. Use a twisting motion if necessary.
Make sure you have inserted it all the way and that the base is locked onto the shaft, then your chair is ready for use.
IMPORTANT:
● Before storing, drain all water that may have accumulated in or around the frames.
● If not drained properly, water can cause freeze damage.
Chelsea Swivel Rocker
272-5374
IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY!
Identify all parts packed in carton against the parts list. Remove all protective materials, place parts on a nonabrasive surface to avoid
scratching. If any parts are missing or damaged, DO NOT attempt to assemble. Please contact our customer service center (Monday-Friday
8:30 a.m.-4:30 p.m. CST) at 1-800-426-2950 or e-mail: [e-mail].
PARTS LIST
Step 1:
Attach the chair bucket (B) into the chair frame (A) using four bolts (AA), four washer (CC). Do not tighten the bolts until assembly is
complete.
Step 2
A. Attach the T-rock (C) to the finished frame using four bolts (BB) in the order of bolt (BB), metal washer (DD), rectangular steel plate (E),
metal washer (DD), spring washer (EE), and nut (FF). NOTE: Bolts are inserted from underneath the seat through the crossbar and into the
T-rock.
B. Tighten all bolts (AA) and nuts (BB) using hex wrench (JJ). Cover all bolts and nuts with plastic bolt and nut caps (GG, HH & II).