Assembly Instructions

25
25
25
Step 2:
Fasten the center connector with ring (#4) to the middle of the
legs (#2) by using bolts (#11). Keep the bolts loose.
See Figure 2.
Step 4:
Turn the table to its upright position. Then put the tiles (#5, #6, #7, #8, #9 and #10) onto the table top (#1) carefully.
See Figure 4 and Figure 5.
Note:
1. If any EVA foams on the table top are missing, there are extra EVA foams in the hardware kit. See Illustration A.
2. To use an umbrella with this table, put the umbrella pole through the table top and center connector ring.
FIGURE 3FIGURE 2
PAGE 2 OF 2
FIGURE 5
FIGURE 4
A
Cleaning and Maintenance
• Wash frame parts with mild soap and water, rinse thoroughly, and dry completely. Do not use bleach, acid, or other solvents
on the frame parts.
• Inspect and tighten all bolts and fasteners on a regular basis to ensure the proper performance and safety of your table.
• When moving the table, remove the umbrella and lift. Do not drag this table.
• We recommend the use of furniture covers when not in use.
• In order to prolong the life and beauty of your table, we recommend that it be stored in a dry and protected area during off
season periods.
• The umbrella should be lowered and/or removed in windy conditions.
E-2
5
7
8
9
1
10
6
The store where you made your purchase
does not stock parts for this item.
If you need parts,
whether they are missing or damaged,
STOP!
Missing A Part?
No Need To Go Back To
The Store
Call us between 9:00 AM and 4:30 PM
Eastern Time Monday through Friday
For further assistance,
please visit us at
[e-mail]
Call Toll Free:
TEL: [phone]
FAX: [phone]
READ THESE INSTRUCTIONS COMPLETELY BEFORE STARTING ASSEMBLY
SEPARATE AND IDENTIFY ALL OF THE PARTS, MAKING SURE THAT
YOU HAVE ALL OF THE PARTS LISTED.
IF YOU DO NOT LOCATE ALL OF THE PARTS LISTED, INSPECT THE
PACKING MATERIAL FOR SMALL PARTS THAT MAY HAVE BECOME
SEPARATED DURING SHIPMENT.
IF YOU EXPERIENCE ANY DIFFICULTY DURING ASSEMBLY OR IF ANY
PARTS ARE MISSING OR DAMAGED, CALL THE HELP LINE AT
1-877-539-7436 BEFORE RETURNING THIS ITEM TO THE STORE.
PROVIDE THE FOLLOWING INFORMATION WHEN CALLING:
1-MODEL NUMBER OF THE PRODUCT.
2-PART NUMBER AND MATERIAL CODE OF THE PART FROM THE PARTS
LIST.
MOST PROBLEMS CAN BE RESOLVED WITHOUT RETURNING THIS
PRODUCT TO THE RETAILER.
Warranty
• This product is covered by Courtyard Creations Inc.'s one–year limited warranty.
• Proof of purchase (dated register receipt) is required for warranty claims.
• It remains the customer’s responsibility for freight and packing charges to and from the service center.
2
2
4
2
11
11
15
#11 BOLT M6*15
2
4
3
3
12
#12 BOLT M6*25
Step 3:
Fasten the center connector with ring (#4) to the middle of the
supports (#3) by using bolts (#12). Make sure that all of the
bolts have been tightened completely. See Figure 3.