Specifications

Print2CAD OCR 2013- 63
Print2CAD
OCR 2013
7.8 Delete Short Lines (Data Reduction)
Some PDF les contain paths with many small lines. This happens mostly when dotted-
lines have been generated in PDF les as single lines. These single lines can easily be
converted to PDF as the paths do not have many parameters or properties.
After the conversion in DWG or DXF, every line will be a full CAD line and may feature
many additional parameters and properties.
This data may strain the capacities of a CAD system and RAM.
The minimum allowed line length can be set with the parameter “d.”
If a line is smaller than parameter “d,” the line gets deleted.
Important!
Dotted lines or hatches may be deleted completely, and therefore may not be avail-
able in the created DWG or DXF le.