Specifications

Print2CAD OCR 2013 - 44
5.2 Output Files
The following output les can be created when converting:
CAD les: DXF or DWG
Raster les: BMP, JPG, PNG, TIFF, RAW, GIF
PostScript les: EPS
PDF les: PDF
5.3 Target Directory for Converted Files
A target directory for the converted les should be specied.
If a target directory is not selected, the output les are created in the same directory as
the source les.
The converted les will have the prex “Print2CAD-.”
This option can be turned off in the conguration.
Note: In this case, the original les will be overwritten without warning. It is therefore
best to leave the prex on until the original data has been copied to another directory or
renamed.
5.4 Conversion of Directories
You may select a directory with source les. All les from this source directory are au-
tomatically converted into the chosen format, and saved to a target directory.
5.5 Version of the Target File
Print2CAD converts into DWG version 14, 2000 to 2013 and DXF les version 12, 2000
to 2013 compatible.
DWG is a native AutoCAD format.
DXF is is a native AutoCAD data exchange format.
Most CAD systems understand DWG version 2004. The DXF version 12 is understood
by many CAD systems, however the quality of the DXF data is not sufcient.