Specifications

Print2CAD OCR 2013- 33
Print2CAD
OCR 2013
Depending on which type of conversion had been chosen, only the appropriate le types
are permitted in the selection.
The converted les have by default the prex “Print2CAD-”.
This prex can be disabled in the conguration, but in that case any existing les that
have the same name and same extension will be overwritten without any warning.
Multiple converted les and the associated settings are saved in the target directory. The
settings le will be designated by the extension .p4c.
Please note the following points
1. The rst le in the list is the most important because the settings of the Assistant
are generated on the basis of the analysis of the rst le and all the other les are
converted with these settings.
2. All the les must be of the same type and have similar contents. Sub-divide your
les into groups with the same contents (e.g. les with primarily text, primarily
design drawings, primarily lled cross-hatching and areas, etc.) and convert the
relevant group separately with the corresponding settings.
3. Never convert in the same group les that had been created in different ways (for
example, les produced by scanners together with les produced by CAD sys-
tems).