Specifications

Print2CAD OCR 2013- 101
Print2CAD
OCR 2013
16. PDF Rights
16.1 Print Permission
If the le does not have permission to extract, which is set by whoever created the PDF,
then the conversion process will require the le to be “printed to...” DWG. This is
checked and performed internally and behind the scenes. However, this results in the
le going through a 300 DPI plot-interface which, if any element or coordinate is not
directly on any one of those 300 dots then the coordinate will be moved to the closest
dot, thereby losing accuracy in the nal drawing. This is a permission situation, and it
may be necessary to calibrate the coordinates (see Section 24).
16.2 Permission to Extract Content
If the permission to Extract Content is enabled in the PDF, then a direct coordinate ex-
traction can occur resulting in the best accuracy of coordinate placement in the nal DWG.
16.3 Encrypted PDF
Converting of encrypted PDFs is not supported.