User Guide

03
Hold the Power Button for 3 seconds to power ON/OFF the board.
*整机出厂时,默认遥控已和滑板配对设置完成
When both the remote and board are in the OFF state, hold the Power Button on both the
board and remote at the same time for 3 seconds to pair.
In the 4WD conguration, the rear controller (ESC1) should be paired before the front (ESC2).
Auto-Pairing
Searching
Select between KM and MILES using the Throttle
Wheel, and press the Power Button on the remote
to conrm your choice.
KMMILES
Unit Selection
Select 2WD/4WD
Hold the Power Button on
ESC1 for 3 seconds
Select the drivetrain setup on your
board using the throttle wheel.
Searching
ESC1
Searching
ESC2
4WD
Unit Selection
2WD
BELT
Unit Selection
HUB
Wheel Size
97
99
98
96
95
GEAR RATIO
2.5
2.7
2.62.4
2.3
Motor PP
6
8
75
4
Complete
2WD ONLY REQUIRES THE PAIRING OF ONE ESC
Pairing Instructions
BACKFIRE
04
Select the number of Pole Pairs for your board's
motor conguration. [Between 2-26]
Pairing and conguration complete.
Select the wheel size of your board using
the throttle wheel.
[Between 90MM-200MM]
Select the gear ratio of your
drivetrain using the throttle wheel.
Hold the Power Button on
ESC2 for 3 seconds
ESC2 ESC1