User manual

the illuminator should be as close as possible to the lower edge of the

visible part of the monitor for maximum eye tracking range.

6) Start the EyeLink host application and click “Set Options” button. Check

the “ELCL Configuration” is set to “Desktop (Angled)”.

7) Ensure the lens cap has been removed from the camera by pulling the

cap outwards while holding the camera.

Figure 3-13: Position and Angle of the Camera for

EyeLink 1000 Desktop Monocular vs. Binocular Mount

8) If you are using the chinrest supplied by the SR Research Ltd., please

install the forehead rest to the chinrest if you haven’t done so yet.

Ask the subject to be seated. Adjust the height of the chair so that the subject

is comfortable and his/her eye line is aligned to upper half of the monitor. Ask

the subject to lean her/his forehead against the forehead rest and adjust the

height of the chinrest so that the subject’s chin sits comfortably on the chin

rest pad. Loosen both the Lock knob on the Desktop Mount, adjust the tilt of

the camera so that the intended eye image appear in the center (vertically) of

the global view of the camera image, and then tighten both the Friction knob

and the Fest/Lock knob to keep the camera in position. Also watch out the

position of the dotted line so that it is aligned with the bridge of the nose. If the

An EyeLink 1000 Tutorial: Running an Experiment