User manual

114 Important Information
© 2005-2008 SR Research Ltd.
6.2 Servicing Information
WARNING: Changes or modifications to camera, illuminators, or cables not
expressly approved by SR Research Ltd. could void the user’s warranty and
authority to operate the equipment. This includes modification of cables,
removal of ferrite chokes on cables, or opening cameras or illuminators.
WARNING: Opening or modifying camera or illuminators, or power supply
substitutions, will void the warranty and may affect the safety compliance of the
system. No user-serviceable parts inside—contact SR Research for all repairs.
CAUTION: Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation exposure.
6.2.1 Non-Serviceable Components:
In the event of failure, the camera and illuminators should be replaced as a
unit, as there are no user serviceable parts inside and no internal adjustments
or jumpers. Please contact SR Research for repair or replacement if you suspect
these are at fault. There are no user-serviceable parts within any of these
components.
6.2.2 Illuminator Replacement:
Before replacing an illuminator, unplug the power supply from mains power
and/or unplug the power cable from the camera. Carefully note the routing of
illuminator cables and the alignment of the illuminator (if adjustable) in order
to restore these during reassembly.
Illuminators are attached to the camera by a short cable with plugs at each
end, and mounted by a large metal heat sink. Do not attempt to disassemble an
illuminator or remove it from its heat sink. Instead, the illuminator should be
detached by <removing clamps or screws or knobs holding it to its mounting>.
If the illuminator cable is fastened to the illuminator’s heat sink, unplug the
cable(s) from the camera; otherwise you may unplug the cable from the
illuminator itself. Dismount the illuminator (instructions for this procedure may
be included in documentation for mounting systems).