Specifications

Allen-Bradley DF1 Driver Help

1746-INI4VI Analog 4 Ch. Isol. Volt./Current Input 8 8

1746-INT4 4 Ch. Isolated Thermocouple Input 8 8

1746-NT8 Analog 8 Ch Thermocouple Input 8 8

1746-HSRV Motion Control Module 12 8

1746-HSTP1 Stepper Controller Module 8 8

1747-MNET MNET Network Comm Module 0 0

1747-QS Synchronized Axes Module 32 32

1747-QV Open Loop Velocity Control 8 8

1747-RCIF Robot Control Interface Module 32 32

1747-SCNR ControlNet SLC Scanner 32 32

1747-SDN DeviceNet Scanner Module 32 32

1394-SJT GMC Turbo System 32 32

1203-SM1 SCANport Comm Module - Basic 8 8

1203-SM1 SCANport Comm Module - Enhanced 32 32

AMCI-1561 AMCI Series 1561 Resolver Module 8 8

Communicating with RSLogix5000 Family Controllers

The Allen-Bradley DF1 Driver can be used to connect to an RSLogix5000 controller's serial port. Users must

configure the RSLogix5000 Controller Tags to be mapped to the PLC/SLC data tables. For information on enabling

communications, refer to the instructions below.

Note:A NULLModem cable is required for this connection.

1. To start, open an RSLogix5000 development software application (such as RSLogix5000 or Studio 5000

Logix Designer). Then, select Logic | Map PLC/SLC Messages.