User manual

Chapter 4: Using the web interface
102 Managing LAN network users
No internet access means no connection to the Internet is allowed. Use
this setting e.g. for IP handsets, where an Internet connection is not
required. The external voice connection is still available; this setting
only affects communication over the Internet.
6. Select Dynamic IP address.
This is the IP address used externally on the satellite network.
If you want to use a static IP address, and your subscription allows for it,
leave this setting at Dynamic. Then select SIM default in step 8 and type in
the APN user name and password from your provider in step 9.
Your terminal will then use the static IP address set up for your SIM card.
7. S et IP Header compression to Enabled or Disabled.
For information on IP Header compression, see Header compression on
page 109.
8. Select the source of the APN (Access Point Name).
There are four options for setting the APN. Unless you have special
requirements, it is recommended to use the SIM default, or to set the
common APN to SIM default, and then select Common here. You have the
following options:
Common. The APN is taken from the Common APN defined under
SETTINGS > Common. Refer to Setting the common interface settings
on page 90.
SIM default. The APN is taken from the SIM card. If you want to use a
static IP address on the external network, select this option either here
or in the Common setting.
Network assigned. The APN is assigned from the network.
User defined. Type in the APN. APNs are provided from the Airtime
Provider.
9. If your APN uses a password, type in the user name and password
provided from the Airtime Provider.
Note
Typing in a static IP address is currently not supported by the
BGAN network.
Note
If you are going to use the static IP address from your SIM card,
the user name and password are mandatory! See step 6 above.