User manual

Chapter 4: Using the web interface
Setting up the interfaces 85
4444
Using the web interface
Configuring the Phone/Fax interface
Do as follows:
1. Select SETTINGS > Phone/Fax from the left navigation pane.
2. For each Phone/Fax port, set the call type for incoming and outgoing calls.
The call types are described in more detail in Selecting the call type on
page 35.
•For Incoming calls, you can check Standard or 3.1 kHz Audio or both.
If you check both, any device connected to the Phone/Fax interface will
react (ring) on incoming calls.
If you select e.g. Standard, the Phone/Fax interface will only react on
calls made to the Standard phone number.
Note
Port 1 is the connector closest to the antenna connector, and Port
2 is the connector closest to the ISDN connector.