User`s guide

Peripheral Devices
Using the Remote Service Feature
Revision D.0 4-25
ssn February 10, 1999 C:\WINNT\Profiles\dapowell\Desktop\D.0 Books\CD FILES SONOS
While the system is being worked on, the Status box is updated:
Exiting Remote Service Mode
After your lab is notified by the local Service Center that the ultrasound system is
ready to be used for imaging, follow these steps to return to live imaging.
1 Use the trackball to select Exit Remote Service Mode and press .
2 After the system warning message appears, highlight Okay with the trackball
and press .
3 Disconnect the modem from the system.
Idle Indicates the system is not logged on to remote service.
Remote User
Connected
Indicates the Service Center is connected to the system.
Working Indicates the system is logged on to remote service, and
is being worked on.
Note that the
information in
the Status box is
not an indicator
that the Philips
Representative
is done working
on the system.
Note that if the
Status box reads
either Remote user
logged on, or
Working, and you
disconnect the
modem, delays in
servicing the system
can occur.
Enter
The system is in Remote Service Mode
Exit Remote Service Mode
Status
Idle
Enter
Okay
The modem and modem cable
must be disconnected from
system prior to performing
any imaging.
WARNING: