User`s guide

Loops
Controls
11-6 Revision D.0
Manual Entry One of the selections available when you turn the
Comment rotary control. Lets you type or change the
disk storage comment. In Disk Setup the comment can
be set to System Generate, Manual Entry, or an
exam type. See “Setup” on page 12-6 for more
information on Comment Options.
Map Changes the color flow map used for selected color
loops. Maps represent conventions and flow
characteristics assigned to the active BART (Blue
Away, Red Toward) or RABT (Red Away, Blue
Toward) map. (Appears on the primary right touch
panel when a color image is displayed.)
Map Invert Switches between the BART (Blue Away, Red Toward)
and RABT (Red Away, Blue Toward) color map
conventions for selected color loops. (Appears on the
primary right touch panel when a color image is
displayed.)
Memory
Gauge
Turns the display of the memory gauge on and off. The
memory gauge shows you how much loop memory has
been used and how much is available.
Replay Shows captured frames in a loop. Available after you
press
during live imaging.
Same Start Makes two or more stored loops begin at the same time.
Available under the Loop Display controls.
Select Loop Outlines the selected loop on the screen, if there is
more than one loop on the page. Enables bookmarking,
editing, and storing of the selected loop.
Select Off Removes the outlines from the displayed loops.
Select Page Outlines one page of loops on the screen. Enables
bookmarking, editing, and storing of the selected page.
Select Region Displays the markers that outline the area of the screen
to be acquired as a loop. Available only when Vsplit
and Cropped formats are active. Touch Select Region
again to remove the markers.
Freeze