User`s guide

Imaging Modalities
PW and CW Imaging
7-90 Revision D.0
Noncardiac secondary
The Meas Bar controls are available only when you are doing an automatic
Doppler trace. To activate the Meas Bar controls, press and then
. To do an automatic Doppler trace, be sure that the Doppler Trace
control is enabled in Setup. To do a manual Doppler trace, press and
then
.
ADP Turns adaptive Doppler on and off. Adaptive Doppler
enhances the signal in a spectral display relative to the
background noise.
Colorize Optimizes contrast resolution by activating the current
colorization map, and overlaying the grayscale image.
To change the active map, turn the color rotary control
just under the Colorize touch control.
Full Screen If an MMode trace is present, toggles between a full
size trace and the last used format defined by Image
Size.
Magnify Increases or decreases the magnification factor of an
image in Zoom or Zoom Preview modes.
Meas Bar
D (time)
Adjusts the position of the Measure Bar D time markers
on a Doppler Trace. The Measure Bar D markers
indicate the end-diastolic velocity and time points (D)
that have been automatically chosen by the system. To
use, first press
.
Meas Bar
D (vel)
Adjusts the position of the Measure Bar D velocity
markers on a Doppler Trace. The Measure Bar D
markers indicate the end-diastolic velocity and time
points (D) that have been automatically chosen by the
system. To use, first press
.
Meas Bar
S (time)
Adjusts the position of the Measure Bar S time markers
on a Doppler Trace. The Measure Bar S markers
indicate the systolic velocity and time points (S) that
have been automatically chosen by the system. To use,
first press
.
Freeze
Trace
Caliper
Trace
Freeze
Freeze
Freeze