Specifications

VENT RITE SPILL ALARM
When and where should this alarm be
installed and used?
This Vent-Rite Spill Alarm should be installed on any natural drafting
appliance that fails a combustion safety test, or on one that is
remaining in the home after energy improvements have been
completed. These appliances may be susceptible to spillage especially
when changes are made to the building.
Appliance
Exhaust
Diverter
Thermal Sensor
Thermal Sensor
Used on
appliances with
Diverter Hoods
• Waters Heaters
• Furnaces
• Boilers
• Coil – Type “L” Copper, with .035" Wall
• Inner core has a .045" wall
• Reduce water heating cost by recovering the heat from drain water
• Easy to install — maintenance free
• Includes couplings for attachment to existing drain pipe
7100.201 Power-Pipe R2-60 2" pipe x 60"
7100.202 Power-Pipe R3-36 3" pipe x 36"
7100.203 Power-Pipe R3-48 3" pipe x 48"
7100.204 Power-Pipe R3-60 3" pipe x 60"
7100.205 Power-Pipe R4-48 4" pipe x 48"
POWER-PIPE DRAIN WATER HEAT RECOVERY
All natural drafting combustion
appliances are susceptible to
back-drafting or “spillage” of flue
gases. This alarm provides an
audible alert when a natural
drafting combustion appliance
begins to spill combustion air
back into the home.
• Used primarily with gas or propane fired water heaters and boilers
• Installs at the appliance
• Has 2 temperature sensors that
get attached to the appliance hood
• The al
arm will alert residents to take action to correct a
potential problem
•
Battery operated, can be re-set easily
• This device measures temperature only — does not
measure pollutants
5020.01 Vent-Rite Spill Alarm
34
Spill Alarm and
Power Pipe
National distributor shipping direct throughout the United States
to place orders or for more information:
800 / 876 / 0660
 fax 888 / 440 / 4219
Wisconsin 800 / 962 / 7015
 Wisconsin fax 920 / 757 / 6452
headquarters 40 Washington Street, Westborough, Massachusetts 01581 • www.efi.org/wholesale