Specifications

Portable Monitor

Instruction 3015-5150 23

3.15 Print/Plot Logged Gas Levels

A printout or plot of the last 200 SF

ppm measurements can be made by connecting the optional

Bacharach printer and printer cable to the monitor as follows (refer to Section 5.1 for printer and cable

part numbers):

1. For a printout or plot to be made, the monitor must have been set up to record gas measurements

using the LOG INT function (page 16).

2. Interconnect the RS-232 connectors located on the printer and monitor.

3. If not already done, refer to the printer manual and set the printer’s communication

parameters to:

• Data bit = 8

• Parity = None

• Baud rate = 19200

• Handshaking = DTR

4. From the Data Display screen, press both the Keypad Left and

Right buttons at the same time to display the first Function

Menu screen. Next, use the Keypad buttons to move the arrow (>)

until it points to either PRINT to produce a printout, or PLOT to

generate a plot.

5. Press ENTER to start the print/plot process.

2ndUNIT >PRINT

PLOT PC-DUMP