Specifications
Instruction 24-94502
Description IrDA Printer
Power Switch
The Power switch, located on the left side of the printer, is used to turn the
unit ON and OFF.
Indicator LEDs
•Power LED (Green): Glows steady when the printer is turned ON.
•Error LED (Red): Flashes once-per-second when the printer is out of
paper;thebufferisfull;orwhentheprintheadtemperatureexceeds
140°F (60°C). This LED will also flash one time when the printer is
placed into its set-up mode (refer to Section Set-Up Mode).
Pushbuttons
• FEED:
- Momentarily press this button to advance the paper. Press and hold
down to feed paper continuously.
- This button in conjunction with the ON/OFF switch is used to start
the printer’s self test function (refer to Section Self Test).
- When the printer is in its set-up mode, this button is used to modify
the selected printer parameter (refer to Section Set-Up Mode).
• SEL:
- Used in conjunction with the ON/OFF switch to place the printer into
its set-up mode (refer to Section Set-Up Mode).
- With the printer in its set-up mode, use this button to select the de-
sired printer parameter.
Sensors
• Paper Out: When the paper roll runs out, the printer is disabled to pre-
vent damage to the print head. This condition is indicated by the Error
LEDashingred.
• Infrared Sensor: Located at the front of the printer, this sensor
receivestheinfraredoutputofanexternalinstrument.