Specifications

Instruction 24-94506
Operation IrDA Printer
Set-Up Mode
The printer has been set up at the factory with the following default
parameters:
Column : 32 column
Baud rate : 9600 bps
Handshaking : DTR
Country : U.S.A.
Printmode :Text(upright)
Paper : Normal paper
Density : 100%
IrDA : IrDA-SIR
If necessary, the default parameters can be changed as follows:
1. With the printer initially switched OFF, press and hold down the SEL
pushbutton, and then switch ON the printer.
2. The printer now goes into its set-up mode as indicated by the red LED
flashing. At this time all of the printer’s current parameter settings are
printed, followed by the first parameter that can be modified.
Note: If no button is pressed within 15 seconds, the set-up
mode is automatically terminated without changing the
original parameters.
3. Column is first parameter printed. Pressing the FEED button causes
thevalueofthatparametertochangeinthesequenceshowninthefol-
lowing table.
SEL Button FEED Button
Column 32, 36
Baud rate 115200, 57600, 38400, 19200, 9600, 4800, 2400, 1200
600, 300
Handshaking DTR, X-on/X-off
Country U.S.A., Turkish, Denmark2, Norway, Japan, Spain,
Italy, Sweden, Denmark1, U.K., Germany, France
 Printmode Text(upright),Data(inverted)
Paper Normal paper, Reprint paper
Density 50 – 150% in 5% steps
IrDA HP-Ir, IrDA-Off, IrDA-Sir, BHT-Ir(DENSO), ELME-Ir,
CHAMJIN-Ir, IrDA 1.0