Specifications

Multi-Zone Gas Monitors
P/N: 3015-5074 Rev 10 25
SECTION 3. SETUP PROGRAMMING
3.1. Initial Power Up
When the MZ monitor is powered up, all front panel LEDs will illuminate and a splash screen will appear,
displaying the monitor’s firmware version level. Note that on CO
2
models, a “Clearing Purge Line”
message is displayed for approximately 2.5 minutes before warm up begins. After a moment, the Warm
Up screen will be displayed and the green MONITOR ON light will blink.
After a 15-minute warm up cycle, the MONITOR ON light will glow steadily and the Data Display screen
will be displayed. (See Appendix C for an overview map of the screens in the system.)
3.2. Data Display Screen
Figure 3-1. Data Display Screen and Front Panel Keypad
3.3. Navigating to the 1
st
Setup Screen
From the Data Display Screen, press the UP or DOWN arrow key. SETUP will be highlighted in the first
box. Press ENTER to select this option and display the Setup screen (see below).
Figure 3-2. System Setup Screen #1
3.4. Navigating to the 2
nd
Setup Screen
From System Setup Screen #1, select the SYSTEM option to go to System Setup Screen #2. Select the
ESC key to return to the System Setup Screen #1.