Specifications

Multi-Zone Gas Monitors
12 P/N: 3015-5074 Rev 10
2.2.7. Connecting the Water Trap
The water trap is an optional accessory for applications that result in water or condensation frequently
entering the intake lines. This is available in a manual style trap (P/N 0007-1655) which is manually
emptied once it has become filled. Install the water trap close to the unit for the most effective results. The
intake line may be cut where the user finds appropriate (preferably close to monitor). Each side of the
intake line should be inserted into the receivers on either side of the water trap. Secure tightly. A
replacement filter (P/N 0007-1656) for the water trap is available and is replaced by unscrewing the clear
plastic cup of the water trap, pulling the filter directly out (do not unscrew), and inserting the new filter into
place. Replace the cup of the water trap. If desired, an optional mounting bracket (0007-1657) may be
used to secure the water trap in place.
NOTE: The termination filter (P/N 3015-3420) or end-of-line water stop filter (P/N 3015-
5512) should be used, regardless of the presence of a water trap.
IMPORTANT: Extreme or humid temperatures may cause water to condense in the tubes.
A water trap is highly recommended for use in these scenarios.
2.3. Interior Components