Specifications

Instructions 77-9045 Bacharach, Inc. Page 1-3
CD3 AUDIT KIT INTRODUCTION
• Digital tachometer (hand held). Photo-electric
unit preferred, mechanical (contact type)
acceptable (readability: ±1 digit)
• Cummins injector, flow code 178A
• Master injector kit, Kent Moore part no.
J-26298 (53,71,149)
• Master injector, Kent Moore part no.
J-29898 (8.2L)
• Two fresh 9 volt alkaline batteries Duracell
M1604, Eveready 522 or others meeting NEDA-
1604A specifications). Operating life of the
batteries is approximately 6 continuous hours.
• Container - minimum 2 quart, maximum 8
quart, with minimum 3 in. diameter opening
and minimum 6 in. high
1.2 INSTALLING BATTERIES
1. Make certain that the clamp force and tempera-
ture indicator is turned off.
2. Remove the battery cover.
3. Connect two 9 Volt batteries to the terminal
clip.
4. Insert the batteries into the holder.
5. Close the cover.
CAUTION
Leaks from batteries can damage the
indicator. Remove dead batteries promptly.
Also remove batteries if the indicator will
not be used for a long time.
If the display indicates “LO BAT,” the
display values may be inaccurate.
1.3 PREPARATION FOR AUDIT
1. Clean the work area. Contaminants will inter-
fere with the audit.
2. Make sure all air lines are intact and contain
no water or particulate matter. Figure 1-2. Battery Holder
CLIPCOVER
BATTERY HOLDER