Specifications

Instructions 67-9319 Bacharach, Inc. Page 1-3
INJECTOR CALIBRATOR CD3 INTRODUCTION
Feature Operation
_____________________________________________________________________
CLAMP MONITOR Monitors the injector body-to-seat clamping force. When clamping
BODY-TO-SEAT force is low, the indicator shows black. When clamping force is
(Cummins) correct, the indicator shows green.
PRESSURE Precision diaphragm-type pressure regulator allows the pressure of
REGULATOR the calibration fluid supply to the injector to be set as indicated on
RAIL PRESSURE gauge the (Injector Supply).
Figure 1-3. Left Table Features
LEFT OPERATOR’S TABLE FEATURES
Feature Operation
_____________________________________________________________________
On/Off Switch For switching the control circuit power on and off.
When switched on, starts the clamp pump motor which
then runs constantly. Also turns on the calibration
fluid automatic temperature control and hour meter.
STOP Button Shuts down main drive motor.
BODY TO SEAT Applies air pressure to the two clamping cylinders that
RELEASE Button drive the body to seat clamp cylinders to the full,
extended (release) position.
HOLD TO OPERATE Unlocks the main clamp cylinder. Functions only when
main drive motor is OFF.
H o l e P r o v i d e d t o
K e e p B a r r i n g T o o l
H O L D T O O P E R A T E
" A " O R " B "
B O D Y T O S E A T R E L E A S E
S T O P S w i t c h
O n / O f f S w i t c
h