Specifications

Instructions 67-9319 Bacharach, Inc. Page 3-5
INJECTOR CALIBRATOR CD3 OPERATION
3.1.5 Mounting Cummins Type PTD
Cylindrical Injectors
Before mounting injectors, check in the cambox to
be sure that the proper cam for the injector to be
tested is mounted on the camshaft. (See Section
3.1.3)
Also make sure the Cummins discharge head has
been installed. (See Section 3.1.4)
3.1.5.1 Inserting Injectors
1. Insert injector into the correct PTD adapter.
Adapter
Injector Part No. Ident.
PTD 3/8 67-6348 3/8 PTD
PTD 5/16 67-6350 5/16 PTD
PTD-K 67-6351 K-PTD
PTD top stop 67-6349 PTD-TS
PTD top stop
(L-10) 67-6972 L-10
PTD K-HVT 67-6997 K-HVT
PTD STC 77-0891 STC
(The PTD (L-10) and PTD K-HVT adapters do not
appear in the photo of Cummins accessories, see
Section 5.14)
2. With adapter slot facing down and the injector
inlet orifice facing up, align injector body drain
hole with corresponding hole in the adapter.
3. Insert locating pin (67-6519).
4. Insert link (67-5703) into injector.
5. Hold these parts in two hands and lower them
into the carrier plate, making sure that:
a. The adapter slot aligns with the protruding
3/8 in. pin.
b. The adapter rests against the semicircular
area of the carrier plate.
c. The link is pushed over the push .
Figure 3-9. PTD Accessories
Figure 3-10. Injector Setup
Figure 3-11. Setting Flywheel
1 PTD Injector1 Adapter
4 Link
Dischar
g
e Head
3 Locating Pin
4 Link
5 Carrier Plate
1 PTD Injecto
r
7 White Painted Area On Flywheel