Owner's Manual

GDX-350 Sensor Transmitter
P/N: 5600-9001 Rev 2 35
5.2. Configuration Using the Magnetic Wand
Passing the magnetic wand past the EDIT key from either data display screen displays SETUP PAGE 1
as shown in Figure 5-3. The UP/DOWN keys maneuver the pointer while EDIT enters sub-levels of menu
items. All SETUP menu items have at least one page of sub-menus. Items with sub-menus are indicated
by the > symbol (right arrow) at the end of each line. Edit menu items by:
• pointing to them
• pressing the EDIT key to display the cursor
• pressing UP/DOWN to change that character
• pressing NEXT to move the cursor
• pressing EDIT again to load the new item and remove the cursor.
Press NEXT to exit the sub-menu. To view SETUP PAGE 2, press the DOWN key with the pointer aimed
at the bottom item on PAGE 1.
L E L I N P U T 2
L C D C o n t r a s t A d j .
Mo d b u s R S 4 8 5 P o r t
S e c u r i t y
T e c h n i c i a n s O N L Y
S e n s o r T e mp
F i r mw a r e R e v .
>
>
>
>
>
“Sensor Temp” menu only present
with “Arctic” smart sensor installed.
See section 7.1.
EDIT
L E L I N P U T 1
S y s t e m C o n f i g .
A l a r m S e t t i n g s
S e n s o r I n f o r ma t i o n
C l o c k / D e l a y s
D i a g n o s t i c s
H E L P
>
>
>
>
>
>
(Instructions)
Figure 5-3: Setup Menu Entry
5.3. System Configuration Menus
The System Config. group consists of two pages of menus as shown in Figure 5-4. Each item’s
description follows in this section.
Figure 5-4: System Configuration Menus
Menu Item Description
Measurement Name
May be edited to contain virtually any 16-character ASCII field. It is typically
used to describe the monitored point by user tag # or other familiar
terminology.
Eunits
Engineering Units - May have up to a 10 character ASCII field. Many common
gases have pre-configured Eunits based upon the sensor type. Each may be
edited in this menu as described in Configuration Using the Magnetic Wand in
Section 5.2 on page 35.
Zero (0%)
Defines the reading to be displayed when 4 mA (0%) is the GDX-350 output.