Specifications

GDC-150 Operation Manual
5209-9000 Rev 0 9
Figure 3-2. Water-Tight Enclosure Showing Mounting Holes
WARNING: Do not drill holes in the back of the base of the enclosure
for the purpose of mounting the sensor/transmitter. Leak paths can
occur. Corrosion damage will not be covered under warranty.
NOTE: Use caution when drilling holes in the water-tight enclosure for
conduit entry so as not to damage the circuit board inside. Use liquid
tight conduit hubs wherever conduit enters the water-tight enclosure.
Failure to do so creates a leak path. Water running down the conduit
enters the interior of the enclosure and could corrode the circuit board.
This is not covered under warranty.
NOTE: When mounting either enclosure, allow enough room to enable
the end user to open the door fully to access the internal adjustments.
3.2. Enclosure Door
The standard enclosure has one screw securing the door to the base for electrical
safety and provides an opening to allow the user to apply a zip tie if they desire the
transmitter to be locked more securely. Refer to Figure 1-1 on page 1.
The door of the standard enclosure can be easily removed to facilitate installation of
the base. Simply grasp the lid with one hand, being careful not to make contact with
any of the internal components (circuit board), and grasp the base with your other
hand. Tug on the base, pulling it towards you. The section of the hinges located on
the base should “snap” apart from the part of the hinges located on the door.