Specifications

Instruction 0024-9435
6
Fyrite Tech
3.3 Connecting the Probe
Connect the probe assembly’s fl ue-gas hose and thermocouple con nec tor to
the analyzer as follows (see Figure 3-2):
1. Push the fl ue gas hose onto the an a lyz er’s GAS inlet fi tting.
2. Push the fl ue gas thermocouple into the T-STACK jack
Important: DO NOT force thermocouple connector. The con-
nec tion tabs are dif fer ent sizes, allowing the connector to fi t
in only one way.
Inspect the fl ue-gas hose for cracks. Replace the hose if it is defective.
Before using the analyzer, check that the Water Trap / Filter is dry and
not dirty. If necessary, dry out the trap and replace the fi lter el e ment per
Section 5.6.