Specifications

Instruction 24-9388

Fyrite Pro

3.0 SETTING UP THE ANALYZER

3.1 Preliminary Steps

Before using the analyzer . . .

• Check batteries (Section 3.2)

• Connect probe to analyzer (Section 3.3)

• Check setup (Section 3.5)

3.2 Checking & Replacing the Batteries

Install fresh batteries as described below. Check the analyzer for sufficient

charge prior to each use. Replace the batteries if the low-battery symbol

appears in the lower right corner of the screen. To replace the bat-

teries:

1. Remove battery cover from back of analyzer.

2. If old batteries are installed, remove them and properly discard.

3. Observing the polarity markings inside the battery compartment,

install four ‘AA’ Alkaline batteries as shown in Figure 3-1.

4. Replace battery cover.

Figure 3-1. Battery Installation

Remove battery cover by

pushing down on cover

and sliding it outward