Specifications

Instruction 0024-9460

Fyrite

INSIGHT

Inspect the flue-gas hose for cracks. If a hose is defective, replace the en-

tire probe assembly.

Before using the analyzer, check that the Water Trap / Filter is dry and

not dirty. If necessary, dry out the trap and replace the filter el e ment per

Section 6.2.

Perform the following steps to connect the probe assembly to the Fyrite

INSIGHT:

1. Push the probe’s sample-gas hose onto the GAS inlet fitting.

2. Push the probe’s draft hose onto the “+” pressure fitting.

3. Push the probe’s thermocouple into the T-STACK jack

Important: DO NOT force the thermocouple connector into

its jack. The con nec tion tabs are dif fer ent sizes, allowing the

connector to fit in only one way.

4. Push the optional ambient/primary-air thermocouple into the T-AIR

jack.