Specifications

Instruction 0024-9460

Fyrite

INSIGHT

3.0 SETTING UP THE ANALYZER

3.1 Preliminary Steps

Before using the analyzer . . .

• Check batteries (Section 3.2)

• Connect probe to analyzer (Section 3.3)

• Check setup (Section 3.5)

3.2 Power

3.2.1 Installing or Replacing Batteries

Install fresh batteries as described below. Check the analyzer for sufficient

charge prior to each use. Replace the batteries if the low-battery symbol

appears in the upper right corner of the screen. To re place the bat ter ies:

1. Remove battery cover from back of analyzer.

2. If old batteries are installed, remove them and properly discard.

3. Observing the polarity markings inside the battery com part ment,

install four ‘AA’ Al ka line bat ter ies.

4. Replace battery cover.

3.2.2 Using the AC Power Adapter

The optional AC power adapter is capable of powering the analyzer on a

continuous basis. The adapter plugs into an appropriate 100-240 VAC wall

outlet and produces an output of +5 VDC. The adapter's output connector

plugs into the analyzer's POWER jack located on the bottom of the unit.

The batteries do not need to be removed when using the AC adapter. Use

only the Bacharach AC Adapter (P/N 24-1254). Failure to do so could dam-

age the unit and will void the warranty.

3.3 Connecting the Probe Hose & Thermo-

couple

A rigid stainless steel probe with handle is connected to a flexible hose

with integral water-trap / filter used to draw a gas sample into the ana-

lyzer from the room, grilles, diffusers, and furnace flues.