Specifications

Monoxor



Plus Manual Setup

0019-9370 Rev 0 10

Section 2. Setup

2.1. Connecting the Probe

A rigid stainless steel probe with handle is connected to a flexible hose with an

integral water trap/filter and is used to draw a gas sample into the analyzer

from the room, grilles, diffusers, and furnace flues.

1. Inspect the flexible hose for cracks. If a hose is defective, replace the entire

probe assembly.

2. Before using the analyzer, check that the water trap/filter is clean and dry.

If necessary, dry out the trap and replace the filter element.

3. Push the probe’s “sample gas” tubing onto the GAS inlet connector.

netzerotools.com