Instruction manual

Setup Fyrite

INSIGHT

Plus Manual
18 0024-9487 Rev 2
2.3. Power Options
Power options include:
• Disposable AA alkaline batteries (included)
• Disposable AA lithium (Li) batteries
• Externally charged rechargeable NiMH batteries
• Power via USB cable (PC or wall adapter).
Check the Fyrite

INSIGHT

Plus for sufficient power prior to each use. Replace
the batteries if the low (or replace) battery symbol appears in the upper right
corner of the Fyrite

INSIGHT

Plus screen.
The battery symbol changes colors from green to red as
battery voltage decreases. In addition, the red Replace
Battery symbol flashes.
The optional USB cable
can be used to power the
instrument in place of batteries. The USB Power symbol
is displayed when the cable is connected between a
Fyrite

INSIGHT

Plus and a computer or wall adapter.
Batteries (4 AA, Fresh or Fully Charged)
Estimated Life Span in Hours
(Continuous, Pump On)
Alkaline (disposable) 15 hours
Lithium (disposable) 20 hours
Rechargeable 8 hours
Replace batteries as follows.
1. Remove the battery cover from the back of analyzer.
2. If old batteries are installed, remove them and properly discard them.
3. Observing the polarity markings inside the battery compartment,
install four ‘AA’ disposable (alkaline or lithium) batteries or four fully-
charged (externally charged) AA rechargeable NiMH batteries.
4. Replace the battery cover.