Specifications

Instruction 24-9460 • Fyrite

InSIght • MyBacharach.com

Setting Up the Analyzer

Preliminary Steps

Before using the analyzer . . .

• Check batteries

• Connect probe to analyzer

• Check setup

Analyzer Turn On and Warm up

1. Remove the back cover and install the 4 AA batteries.

2. Connect the probe and hose assembly. Note the combustion hose fitting is slightly larger

in diameter than the pressure hose fitting. The stack thermocouple plugs into the yellow

connector on the left hand side with the wider prong on the right.

3. Turn ON the analyzer by pressing the PWR button for a second until the pump starts up and

the display comes on. For several seconds you will see the Version, Model Number and Serial

Number of the instrument displayed, the instrument will then start a 60 second countdown to

allow the sensors to calibrate. NOTE: make sure the probe is sampling fresh air during these

60 seconds. To set the time/date and other settings go to the SETUP section.

4. The first screen that comes up is in the HOLD position. To start sampling press the RUN/

HOLD button. The backlight will be illuminated at start-up.

Fuel Type

1. The FUEL TYPE will be displayed at the top of the screen. To change to another fuel, press the

MENU (F2) button, the MAIN MENU will be displayed with the FUEL selection highlighted.

Press the round, green, ENTER button in the center of the keypad to select FUEL, scroll the up/

down keypad until the cursor is highlighting the desired fuel and press the ENTER button. That

will return you to the HOLD screen; press the RUN/HOLD button to continue operation.