Folding Cot INSTRUCTION MANUAL Complies with Australia/New Zealand Standard AS/NZS 2195:2010 IMPORTANT: Thank you for choosing our product. Please read and understand these instructions before using this folding cot. If in doubt, please seek help from our Customer Service Team. Please retain the instructions for future reference. Images in this manual are representative only. Actual product may vary. The manufacturer reserves the right to change specifications without prior notice.
SAFETY THANK YOU FOR CHOOSING OUR PRODUCT. PLEASE TAKE TIME TO READ THE IMPORTANT SAFETY NOTES BELOW. THIS WILL ENSURE MANY YEARS OF HAPPY AND SAFE USE. IF IN DOUBT, PLEASE SEEK ASSISTANCE FROM OUR CUSTOMER SERVICE TEAM. INCORRECT ASSEMBLY MAY MAKE THE COT UNSAFE. DO NOT USE THIS COT IF ANY PART IS BROKEN, TORN OR MISSING. WARNING WARNING! Be aware of the risk of open fires and other sources of strong heat, such as electric bar fires, gas fires, etc.
1 – PARTS LIST 1 2 3 4 5 6 Plastic Corner Brackets Folding Connector Leg Pole Plastic Foot Base Rail – short Side Rail Assembly 7 8 9 10 11 Centre Foot Base Rail – long Hinge Bracket Top Rail - short Top Rail - long WARNING Keep children away when assembling or disassembling this folding cot. IMPORTANT: A mattress is included with this folding cot – it is specifically designed to suit this product.
2 - SETTING UP THE FOLDING COT Unzip and remove the carry bag Fig 1, and then remove the mattress base by unfastening the three loop/hook fastenings straps Fig 2, and take out the folding cot. Pull apart the tops of the 4 legs as shown in Fig 3. Starting with the shorter sides, pull up the Side Rails with both hands quickly to lock them in place. (Note that these rails are covered by the fabric of the cot sides.) Fig 4 Repeat with the two longer sides.
Push down on the Centre Foot in the middle of the base until the base lays down flat & it clicks into place. Fig 5 Place the supplied Rigid Mattress Base into the folding cot and fix it in place by feeding the loop/hook fasteners through the slits in the Folding Cot base and attaching them to the underside of the base. Fig 6 Note – DO NOT use the Rigid Mattress Base without it being secured to the Folding Cot.
3 – FOLDING THE FOLDING COT Release the loop/hook fastening straps that secure the mattress to the cot and remove the mattress from the Folding Cot. Pull up on the tab attached to the Centre Foot to lift it out of engagement. Pull the base up at least 2/3 of the way to the top. – Fig 7 Release each Top Rail by lifting the Folding Connector slightly and squeezing the locking button on the underside of the Connector, and then push down so the top rails form a “V” position.
If the side rails do not all fold evenly, lift them up and repeat previous operations until all 4 sides are fully folded down evenly. Fig 10 IF THE TOP RAILS DO NOT FOLD – DO NOT FORCE THEM – LIFT UP THE CONNECTORS AND SQUEEZE THE BUTTONS AGAIN TO FULLY RELEASE THEM. Pull all 4 legs into the centre and arrange the frame and cover properly, so that the rigid base can be wrapped around it and fastened with its loop/hook fastenings. straps – Fig 11. Place back into its carry bag. Fig 12.
4 - CLEANING AND MAINTENANCE Clean off dust and loose dirt by vacuuming at lowest possible power. Wipe over with a damp cloth with soap and warm water to remove ingrained dirt. Check the fabric and padding for any damage from tearing or holes. WARNING Use only the mattress supplied by the manufacturer of this folding cot.
