Operation Manual

52
EN
> The LED indicators corresponding to the selected level of
intensity will light up.
N.B.: Homelight® is programmed to intensity level 1 by default.
3. Place the application surface on the desired area of skin,
establishing complete contact with it.
> The READY LED indicator will start ashing.
4. Press the trigger button.
> Homelight® will release a light pulse.
N.B.: You may feel a slight hot sensation and tingling.
5. Remove the application surface from the treated area of skin.
6. Move the application surface to a different treatment area.
> The READY LED indicator will light up again after about 2
seconds. Homelight® is now ready to release another light
pulse.
B. Gliss (Glide) mode
In Glide mode, the light pulses from your Homelight®
are released automatically and constantly without any
additional actions being necessary (36 light pulses per
minute, constantly, at level 1).
Follow these steps
1. To activate Glide mode, repeat steps 1 and 2 for Precision mode.
Then correctly place the application surface of Homelight® against
your skin whilst holding down the trigger button on the device.
2. Glide Homelight® over your skin without interruptions, in a
G945-G946E IB 1.indd 52 02/06/2015 11:31 AM