Operation Manual

56
EN
No pulses are released when you press the trigger button
• Make sure that the application surface of Homelight® is fully in
contact with the skin and the ON/OFF/READY LED indicator is
flashing.
• Make sure that the ON/OFF/READY LED indicator is on.
> If the ON/OFF/READY LED indicator is still off after 10
seconds, switch Homelight® off and on again by pressing
the ON/OFF button twice.
> If the problem persists, contact BaByliss Customer Services
for your region.
• The ON/OFF LED READY indicator is glowing red and flashing
> Switch Homelight® off. Homelight® goes into safety
mode because it has detected overheating or a critical
problem (broken fan, problem with the capacitor, etc.). Let
Homelight® cool down for 15 minutes before turning it on
again.
> If the problem persists, contact BaByliss Customer Services
for your region.
• The ON/OFF/READY LED indicator flashes alternately green and red.
> The adapter used to connect your Homelight® device to
the power socket is not the one supplied or it is broken.
> If the problem persists, contact BaByliss Customer Services
for your region.
• The ON/OFF/READY LED indicator is at red.
> The device is now at the end of its service life.
6.2. Customer Services
For further information about Homelight® products, please visit www.
babyliss.com.
If Homelight® is broken, damaged, needs to be repaired or if you need
any kind of assistance, please contact BaByliss Customer Services.
7. Specifications
Point of impact, Specs 3.0 x 1.0 cm = 3.0 cm
2
Repetition rate At level 1, one pulse every 1.6 seconds.
At level 5, one pulse every 3.5 seconds.
Light intensity At level 1: 2 J/cm²
At level 2: 2.5 J/cm²
At level 3: 3 J/cm²
At level 4: 3.5 J/cm²
At level 5: 4 J/cm²
Wavelength 550 - 1200 nm
Required wiring 100- 240 VAC, 3A
CE marking
Follow the instructions for use
Moisture protection: standard
8. Recycling, packaging and labelling
ELECTRICAL AND ELECTRONIC EQUIPMENT AT THE END OF ITS
SERVICE LIFE
In everybody’s interest and to participate actively in the joint
effort to protect the environment:
• Do not discard your products with the household waste.
• Use whichever return and collection systems are available in your
country to recycle or recover certain materials.
This device is not intended to be used in the presence of a flammable
anaesthetic mixture with air, oxygen or nitrous oxide.
G935E-G933E_IB 1.indd 56 09/06/2015 8:38 AM