Operation Manual

50
EN
3. Place the application surface on the desired area of skin,
establishing complete contact with it.
> The ON/OFF/READY LED indicator will start ashing.
4. Press the trigger button.
> Homelight® will give o an LED pulse.
N.B.: You may feel a slight sensation of warmth and tingling.
5. Remove the application surface from the treated area of skin.
6. Move the application surface to a different treatment area.
> The ON/OFF/READY LED indicator will light up again after
about 2 seconds. Homelight® is then ready to emit another
pulse.
B. Gliss (Glide) mode
In Glide mode, the light pulses from your Homelight®
are released automatically and constantly without any
additional actions being necessary (36 light pulses per
minute, constantly, at level 1).
Follow these steps
1. To activate Glide mode, repeat steps 1 and 2 for Precision mode.
Then correctly place the application surface of Homelight® against
your skin whilst holding down the trigger button on the device.
2. Glide Homelight® over your skin without interruptions, in a
slow, continuous movement, without making any up or down
movements.
N.B.:
• If you remove Homelight® from your skin whilst holding down the trigger
G935E-G933E_IB 1.indd 50 09/06/2015 8:38 AM