User manual

5.20 | Design Menu Pro-Stcher User Manual
To join vercally repeated designs
• To link designs vercally, ensure the start and end points are at the same horizontal coordinate.
Then select Vercal Point 2 Point to align the designs such that the end point of the rst design
matches up with the start point of the next design.
NOTE: To manually enter a distance value between the designs in either the horizontal or vercal
distance box, you must rst turn o Point 2 Point.
Repeat Wrapping
Use the wrapping opons in conjuncon with repeated designs. The opons enable you to shi
rows or columns of repeated designs, or oset the enre design window. Typically you will wrap either a
row or a column, but not both.
• On the Design menu, select Repeat, then select Wrapping.
Removes all of the
wrapping acons
and resets the
design to its
unwrapped state.
Column wrapping
opons
Vercal window
wrapping opons
Column wrapping
opons
Horizontal window
wrapping opons
!
Repeated Bapst
Fan design has been
joined vercally and
horizontally with
Point 2 Point.