User manual

Pro-Stcher User Manual Design Menu | 5.19
To stretch a design to ll an area
You can stretch a design to t either the width or the height of an area.
• First dene an area and then choose either the Stretch Width or the Stretch Height buon.
To calculate the opmal number of repeats for an area
• Press Fit to have Pro-Stcher calculate the opmal number of repeats in both height and width. You
can add more horizontal or vercal repeats as desired and then select Stretch Width and Stretch
Height to t them to the area.
Point 2 Point
Some designs are intended to be linked together horizontally or vercally but must be overlapped for
the start and end points to match up. The Point 2 Point buons link the start and end points of repeated
designs. The following image shows the design before selecng Point 2 Point. (beer screen shot)
To join horizontally repeated designs
• To link designs horizontally, ensure the start and end points are at the same height, or vercal coor-
dinate. Then select Horizontal Point 2 Point to align the designs such that the end point of the rst
design matches up with the start point of the next design.
Stretches the
design to t the
width of the area.
Calculates the
opmal number of
repeats both
vercally and
horizontally.
Stretches the design
to t the height of the
area.
Aligns horizontally
repeated designs
such that the end
point of the rst
design matches
up with the start
point of the next
design.
Aligns vercally
repeated designs
such that the end
point of the rst
design matches up
with the start point
of the next design.