User manual

5.18 | Design Menu Pro-Stcher User Manual

Repeat Menu

The Repeat Main funcon provides several opons for repeang a design.

• Select Design, Repeat, and then Main.

The Repeat Wrapping funcon provides several opons for wrapping, or oseng, designs. Most of these

opons can be done with or without a dened area.

• Select Design, Repeat, and then Wrapping.

Using a dened area in conjuncon with the Repeat opons will stretch, skew, or t the desired number

of repeats within that area. If an area has not been dened, the opons to stretch and t will be disabled

because they require an area to stretch or t to.

Repeat Main

To repeat a design

• Press the Plus Sign (+) to increase the number of mes you want to repeat a design. To decrease

the number of repeats that appear on-screen, press the Minus Sign (–).

• Alternately, tap on the number box and enter the desired number of repeats into the pop-up num-

ber box. Then press Enter.

NOTE: If the repeated design includes jump points, Pro-Stcher preserves them when you save the

design.

To change the size of the gap between repeated designs

• Enter a value (in inches) in either the Horizontal Distance box or the Vercal Distance box to

increase the size of the gap between repeated designs. To overlap the designs, enter a negave

value.

Vercal repeat

opons: Enter the

number of repeats,

or press the Plus

Sign to increase the

number of repeats

or the Minus Sign to

decrease the number

of repeats.

Horizontal repeat