User manual

Pro-Stcher User Manual Design Menu | 5.13
To ne tune the angle of rotaon
• Redene either the start point or the end point as necessary by moving the quilng machine to a
new locaon and pressing either 2 Point Start or 2 Point End, depending on which end of the line
needs to be reposioned.
NOTE: A start point on the le followed by an end point on the right (i.e. a straight line with start
on the le and end on the right) is a 0° rotaon, or no rotaon. A start point on the right and an
end point on the le (i.e. a straight same line, but with the start and end points reversed) is a 180°
rotaon, or in other words, the design will be upside down.
!