Troubleshooting guide

Page 46
Reset Current Resume Postion
After locating the desired starting point in the pat-
tern (either using the “New Start Point” feature or
the “Back Up” feature), the user may notice that the
quilt has shifted slightly so that the resume point in
the pattern does not line up exactly with the cor-
rect point on the quilt. The simplest way to correct
this is to disable the motors by toggling the “Enable
Motors” button and move the needle to the precise
desired point on the quilt. Then press the “Reset
Current Resume Position” button and the pattern
will be shifted to line up the resume point of the pat-
tern with the current needle position on the quilt.
Nudge
Another option for shifting the pattern to line things
up due to either the quilt shifting or draw-in of the
quilt is to use the “Nudge” option. Use this function
as described previously in Step 6 on page 37.
Resume
Once the new starting position has been determined
and any positioning adjustments needed have been
made, press the “Resume” button to resume quilting.
Upon pressing the “Resume” button, the user will
be able to confirm or change the current stitching
options. The only difference between this screen
and the options given at the beginning of a pattern is
the “Current Pattern” option under “Tie-Off.” If this
option is selected, a tie-off will occur as soon as the
pattern resumes, even though it may not be at the
beginning or end of a pattern. (Figure 52) Press the
“Resume” button once more to begin stitching, or
the “Cancel” button to return to the “Pause Screen” .
Figure 52